98.01 €
(tax incl.)
This one coax output beverage antenna has got internal relay for direction switching.
4-way beverage antenna system REMOTE CTRL & BI-DIR 2WIRES F
This antenna system consists of 2x Bi-dir beverage sets, 4-way antenna switch and controller.
611.05 €
(tax incl.)
Instead of 618.31 €
611.05 €
505.00 € (without tax)
505.00 € (without tax)
Brand:
Add to compare0
Love
Add to wishlist
This antenna consists of 2x Bi-dir beverage sets, 4-way switch and K9AY/4-way controller. That all allows you to have 4 directions beverage antenna system with only one coax line from field to the controller. Controller have got Bias Tee (AC/DC), HPF (kill AC noise), internal PCB with 3 BPFs, preamp and protections. There is also RX/TX RF switch for TRX which does not have input for RX antenna.
Main functions
- Low noise RX antenna system
- Broadband 0.1 to 30 MHz
- 4 directions beverage/K9AY
- Small room for K9AY, larger for beverages
- 50/75 Ohm feed line tolerant
- Built-in Bias Tee AC/DC
- PREAMP with variable gain 0 to 18 dB
- Three switchable BPFs or BYPASS
- RX protections and limiters in controller
- RX source switch for TX and RX antenna
- Possible REMOTE control
Controller
- Universal box for K9AY or 4-way Bi-Dir beverage system - front panel image
- 4-way beverage system can have 4 construction positions in the field - more info in manual
- FOUR direction switch
- Including Bias Tee AC/DC for RX antenna
- HPF > 100 kHz as AC noise eliminator (80 dB at 20 kHz)
- Front End protections
- RF power limiters in RX line
- LED Indicator LOCAL/REMOTE - image
- LED direction indicator 0 or 45 deg. - image
- Three BPFs and Bypass - 4 positions switch on the front panel
- Internal PCB with BPFs and preamp
- RX SOURCE switch - selecting TX or RX antenna for receiving - More info: image and manual
- Preamplifier switch and LED indicator
- POWER SUPPLY MUST BE 12V AC not DC
- REMOTE CONTROL READY
- SMD + THT construction
- Stainless screws and nuts
- High quality connectors
- ASSEMBLED VERSION
Remote Control Notes
- There is NO IP/web based remote control inside the box. RJ45 connector is only for DC voltage between controller and feeder. Remote Control can be done by the DB15M connector at the rear panel. When you apply +12 to +14 V DC to direction pin at this connector, relay automatically deactivate front panel switches and you can control it over these external voltages at DB-15M Remote Control connector. All LED indicators still work. Please, read the manual.
- We offer now two IP controllers: OLI IP 12 and powerful REMOTIUS 64.
Bi-directional beverage antenna ONE coax output
- Broadband 0.2 to 30 MHz
- Bi-directional - two directions with one beverage antenna
- Low noise
- Twinlead or open wire line
- 50/75 Ohm feed line version
- Two construction versions: Classic (antenna in the air) or BOG (beverage on ground)
- ONE coax output to 4-way middle switch
- One coax version is switchable by positive voltage (+12V)
- Common-mode coax choke at output included
- Electrostatic protection with neon lamps
- Stainless screws and nuts
- High quality connectors
- IP56 boxes - recommended to protect it against water
- Feeder size 100x100 mm
- Terminator size 64x58 mm
- ASSEMBLED VERSION
4-way beverage switch
- Broadband - 0.1 to 50 MHz
- High voltage protections
- 50 or 75 Ohm feed line version
- Common-mode coax choke included for OUTPUT port
- Control voltage up to 15 V AC/DC
- Switch is controlled by -12V DC or AC
- Maximal current ups to 300 mA
- Insertion loos less than 0.5 dB
- Common-mode current choke with isolation over 30 dB at output port
- Electrostatic protection with neon lamps
- High quality connectors
- Stainless screws
- IP56 box - recommended to protect it against water
- Size 100x100 mm
- ASSEMBLED VERSION
Parameters
- Power supply 12-14 V AC! min. 1.5 A - with DC power supply you will not be able to switch directions over the coax line
- Preamplifier with 1 W NPN transistor 2SC5551A
- Preamp BIAS current 10 to 70 mA
- Gain: up to 18 dB
- Noise Figure (NF) < 2 dB
- REAL OIP3 34 dBm
- Input HPF > 50 kHz (AC limiter)
- BPF insertion loss lower than 1 dB
- Bias Tee AC/DC max. 350 mA (for 4-way beverage system)
- HPF > 100 kHz as AC noise eliminator (80 dB at 20 kHz)
- TX power from TRX to TX antenna port up to 400 W
- PTT IN/OUT - only loop, no delay, TX to GND
- PTT logic is 5 V compatible (OM-power)
Available as
Controller version: remote
Connectors: F
Version: 2wires classic (wire in the air)
Other versions: available versions of 4-WAY SYSTEM - other versions on request
- OLI IP 12
- REMOTIUS 64
- D-SUB 15 female 1m cable or D-SUB screw terminal
- Power supply 13.8 V 30 A analog or digital version
- Common-mode current choke
- K9AY simply loops switch
Included in package
4-way switch assembled and tested
2pcs Bi-Dir beverage assembled and tested
Controller assembled and tested
DC plug - image
DB15 male connector with cover
DB15 female connector with cover
Technical articles
Please check our technical articles about REMOTE SYSTEM.
Manual
If you want to know more please check our wiki with 4-way beverage antenna system with controller manual.
K9AY/4-way controller
K9AY/4-way controller block diagram
Bi-directional beverage antenna classic version with F connector
4-way beverage switch with F connector
Band Pass Filters characteristic with preamplifier
160m BPF with preamp
80m BPF with preamp
40m BPF with preamp
BYPASS with preamp
example for 4-way beverage system with K9AY simply loops switch antenna
Remote Control example
We offer two web-based controllers. OLI IP 12, which is directly designed for K9AY++, 4-WAY and 7ANT RC controllers and REMOTIUS 64, bigger controller which could control more parts and offers more outputs.
There is more ways for remote control:
- Classic UI
- Beam Map
- Stream Deck, NodeRed or custom system
Option: Common-mode current choke
Data sheet
- type
- ASSEMBLED
- controller
- with controller
- product dimensions
- 65x58x35 mm - PU box IP56
100x100x50 mm - PU box IP56
- product weight (brutto)
- 3.2 kg
- package dimensions
- 26x35x27 cm
You may also like
95.59 €
(tax incl.)
Common mode choke coils work as a simple wire against differential mode current (signal), while they work as an inductor against common mode current (noise).
127.05 €
(tax incl.)
Common mode choke coils work as a simple wire against differential mode current (signal), while they work as an inductor against common mode current (noise).
88.33 €
(tax incl.)
This is two port antenna switch - middle box between pair of Bi-Directional antennas with single coax output.
98.01 €
(tax incl.)
This one coax output beverage antenna has got internal relay for direction switching.
105.27 €
(tax incl.)
This is simply K9AY feeder box with direction switch, variable and fixed Rload and protections. Coaxial output has got common-mode current filter.
39.93 €
(tax incl.)
Linear power supply 12 V AC 1.7 A with classic transformer and current protection.
185.13 €
(tax incl.)
This is IP controller designed for direct connection to K9AY++ and 7ANT RC controllers.
326.70 €
(tax incl.)
This is IP controller designed for direct connection with our K9AY++/4-way and 7ANT controllers.
8.47 €
(tax incl.)
D-SUB solderless connector with terminal screws connection - DIY
8.47 €
(tax incl.)
D-SUB solderless connector with terminal screws connection - DIY
67.76 €
(tax incl.)
Common mode choke coils work as a simple wire against differential mode current (signal), while they work as an inductor against common mode current (noise).
333.96 €
(tax incl.)
This is an interesting antenna controller with built in BPF, preamp, protections, bias tee, RX/TX antenna switch and much more. It is designed for K9AY (and similar loops) and for the four-way Beverage system....