Common-mode current choke 1-PORT
Common mode choke coils work as a simple wire against differential mode current (signal), while they work as an inductor against common mode current (noise).
56.00 € (without tax)
Common-mode choke coils work as a simple wire against differential mode current (signal), while they work as an inductor against common-mode current (noise).
Using
- Common-mode filter for coax cable
- RX antennas, active antennas etc.
Main functions
- Common-mode current insulator
- High current insulation
- Impedance 50 or 75 Ohm
- High quality PTFE coax cable
- High quality connectors
- Low insertion loss
- IP56 box - recommended to protect it against water
- Feeder size 100x100 mm
- ASSEMBLED AND TESTED VERSION
Parameters
- Insertion loss lower than 0.2 dB (at 50 MHz)
- Common-mode isolation better than 30 dB (7 MHz and lower)
- RF power up to 100 W
Available as
ASSEMBLED: ready to use
KIT: all parts + PCB and IP56 box - KIT VERSION
Connectors: PL SO-239 or F
Included in package
CMCC assembled and tested
Manual
If you want to know more please check our wiki with common-moder current choke manual.
1-PORT version with PL SO-239 connector
1-PORT version with F connector
effect of CMCC
example of installation
example of right configuration with Single wire beverage BOG
1 to 50 MHz
0.1 to 2.5 MHz
Insertion LOSS of CMCC - for 50Ohm RG-316 coax cable 10 turns
available also Common-mode Current Choke Control Cable
Data sheet
- type
- ASSEMBLED
- design
- in enclosure
- usage
- RX
- front-end protection
- none
- frequency range
- DC to 60 MHz
- product dimensions
- 100x100x50 mm - PU box IP56
- product weight (brutto)
- 0.31 (BNC), 0.32 (F), 0.37 (N, PL) kg
- package dimensions
- 18.5x14x10.5 cm
Specific References
- ean13
- 1000090107657