No produts were found.

Click for more products.

No produts were found.

0.00 €

Home
/
Products
/
RX PARTS
/
RX antennas
/
Beverages
/
Single wire beverage on ground KIT

Single wire beverage on ground KIT

Beverage antennas provide one of the least expensive and most reliable ways to improve DX capabilities on the low frequencies.

Using

Low band receiving antenna
Lower noise, better directivity
Can be part of phased array
BOG = Beverage On Ground

Main functions

Broadband 0.1 to 30 MHz
Single directional
Low noise
Beverage element is on the ground
Protections - high voltage/current
Termination resistance selectable in three steps
50/75 Ohm feed line - easy jumper switch
Common-mode coax choke included
Electrostatic protection with neon lamps
High power protection
Stainless screws
High quality connectors
IP56 boxes - recommended to protect it against water
Feeder size 100x100 mm
Terminator size 64x58 mm
KIT VERSION

Parameters

Coax impedance 50 or 75 Ohm (internal jumper)
Construction as you need.
Beverage element (wire) is directly on ground - no supports needed.

Available as

KIT: all parts + PCBs and IP56 boxes
ASSEMBLED: ready to use - ASSEMBLED VERSION
Connectors: PL SO-239 or F
PCB: only PCBs

KIT contains

PCBs - feeder and terminator
box IP56 (100x100 mm and 64x58 mm)
connector (PL SO-239 OR F)
neon lamps
resistors
PTC resettable fuses
ferrite cores
binocular core
pin headers, jumpers
fasteners (screws, nuts, washers, ring terminals, spacer bolt)
coax cable
Cu wire
wires
holder for common-mode coax choke
stickers
paper drilling template
PCB for F connector

⚠ IMPORTANT NOTE: THIS PRODUCT IS A KIT - you have to assemble it by yourself!

Manual

If you want to know more please check our wiki with Single wire beverage on ground manual.

version with PL SO-239 connector

version with F connector

assembled version with PL SO-239 connector

assembled version with F connector

assembled version of terminator

block diagram

example of right configuration with CMCC

typical SWR

2EL End-Fire beverage antenna array BOG

235.95 € (tax incl.)

This is 2 element beverage antenna array. In this End-Fire array the beverage antennas are very close to each other. Usually 2 to 6 meters. One beverage is shifted to front by the stagger distance. This array needs...

PCBs for Single wire beverage CLASSIC

16.94 € (tax incl.)

Beverage antennas provide one of the least expensive and most reliable ways to improve DX capabilities on the low frequencies.

PCBs for Single wire beverage on ground

16.94 € (tax incl.)

Beverage antennas provide one of the least expensive and most reliable ways to improve DX capabilities on the low frequencies.

Single wire beverage CLASSIC

83.49 € (tax incl.)

Beverage antennas provide one of the least expensive and most reliable ways to improve DX capabilities on the low frequencies.