98.01 €
(tax incl.)
This one coax output beverage antenna has got internal relay for direction switching.
Bi-Directional beverage antenna 1 coax output KIT
This one coax output beverage antenna has got internal relay for direction switching.
64.13 €
(tax incl.)
64.13 €
53.00 € (without tax)
53.00 € (without tax)
Brand:
Add to compare0
Love
Add to wishlist
There are two beverage antennas receiving in opposing directions to share the same space. That provides one of the least expensive and most reliable ways to improve DX capabilities on the low frequencies. The transformer at the end of the beverage is designed to match impedance of the antenna. A two-wire bi-directional beverage requires the antenna element to operate a balanced transmission line. The parallel wire line used to construct the antenna must be excited under near-perfect balanced transmission line conditions.
Using
- Low band receiving antenna
- For LF, MF and HF SWL
- Lower noise, better directivity
- Can be part of phased array
Main functions
- Broadband 0.2 to 30 MHz (optimal 0.2 to 14 MHz)
- Bi-directional (reversible) beverage antenna
- Low noise
- Very good F/B ratio
- Twinlead or open wire line
- Classic or BOG construction - as you need
- 50/75 Ohm feed line version
- Isolated ground to prevent common-mode noise
- Common-mode coax choke at output included
- Free configuration for your beverage parameters
- Simply transformer calculator
- One coax version with switchable direction by positive voltage (+ 12V or AC) - you can build it also with negative voltage control
- Electrostatic and HV protection with neon lamps (> 65V AC)
- High power protection
- Stainless screws and nuts
- High quality connectors
- IP56 boxes - recommended to protect it against water
- Feeder size 100x100 mm
- Terminator size 64x58 mm
- KIT VERSION
Parameters
- Feed line impedance 50 or 75 Ohm - version depends on order
- Antenna impedance - as you need and calculated
- Common-mode choke isolation more than 30 dB
- Antenna element in the AIR or BOG
- One coax output with internal relay switch in feeder
- Direction switch needs + 12V / 0.1 A (or AC 12V) - switching by positive voltage
- ANT reception: REVERSE direction with 0 V, STRAIGHT with +12 V
Available as
KIT: all parts + PCBs and IP56 boxes
ASSEMBLED CLASSIC: ready to use - CLASSIC VERSION
ASSEMBLED BOG: ready to use - BOG VERSION
Connectors: PL SO-239 or F
PCB: only PCBs
KIT contains
- PCBs - feeder and terminator
- box IP56 (100x100 mm and 64x58 mm)
- connector (PL SO-239 OR F)
- neon lamps
- resistors
- capacitors
- PTC resettable fuses
- diodes
- 3-pole wago
- inductor
- ferrite cores
- binocular core
- pin header, jumper
- fasteners (screws, nuts, washers, ring terminals, spacer bolt)
- coax cable
- Cu wire
- relay
- varistor
- wires
- holder for common-mode coax choke
- stickers
- paper drilling template
- PCB for F connector
Manual
If you want to know more please check our wiki with Bi-Directional beverage antenna 1 coax output manual.
version with PL SO-239 connector
version with F connector
assembled version with PL SO-239 connector
assembled version with F connector
assembled version of terminator
example with 4-way Bi-Dir beverage and Bias Tee Box
example with Bias Tee Box
example with Bias Tee Box and Preamp Box
Data sheet
- type
- KIT
- design
- in enclosure
- usage
- RX
- impedance
- both 50 & 75 Ohm
- front-end protection
- input
- frequency range
- 0.2 MHz to 30 MHz
- product dimensions
- 65x58x35 mm - PU box IP56
100x100x50 mm - PU box IP56
- PCB dimensions
- 50x33 mm
95x40 mm
- product weight (brutto)
- 0.47 (F), 0.49 (PL) kg
- package dimensions
- 18.5x14x10.5 cm
Specific References
- ean13
- 1000090096630
You may also like
96.80 €
(tax incl.)
This two coax output beverage antenna has got two output connectors with opposite directions at the same time. It is ideal for SO2R or MM as antenna direction sharing.
98.01 €
(tax incl.)
This one coax output beverage antenna has got internal relay for direction switching.
96.80 €
(tax incl.)
This two coax output beverage antenna has got two output connectors with opposite directions at the same time. It is ideal for SO2R or MM as antenna direction sharing.
90.75 €
(tax incl.)
RX preamplifier with variable gain, protections and power over coax.
76.23 €
(tax incl.)
A bias tee is used to insert AC or DC power into an HF signal to power remote antenna preamplifiers (DC), Bi-directional beverages (AC) or other devices.
75.02 €
(tax incl.)
A bias tee is used to insert DC power into an HF signal to power remote antenna amplifiers or other devices.
16.94 €
(tax incl.)
PCBs for one coax output beverage antenna.
64.13 €
(tax incl.)
This two coax output beverage antenna has got two output connectors with opposite directions at the same time. It is ideal for SO2R or MM as antenna direction sharing.
16.94 €
(tax incl.)
PCBs for two coax outputs beverage antenna.
309.76 €
(tax incl.)
This is antenna controller for K9AY and Bi-directional beverages. You can use DC control wires as well as AC/DC voltage over the coax to antenna. There are Band Pass Filters and preamplifier directly in the...