TinySA spectrum analyzer
Handheld 2.8inch TinySA Version V0.3.1_E
60.00 € (without tax)
This is a very powerful handheld Spectrum Analyzer with RF signal generator. It is new version 0.3.1_E. The display is a 2,8 inch touch display with 320x240 pixels resolution and 16 bit depth. You can use resistive touch or Jog switch control. Color display showing max 290 points providing gapless covering up to the full frequency range. Switchable resolution bandpass filters from 3 to 600kHz. Internal attenuators 0dB to 31dB (cannot be used in combination with LNA). Rechargeable battery allowing a minimum of 2 hours of portable use. There is NO SD slot and Audio output.
Applications
- Spectrum Analyzer
- RF generator
- Spectrum monitoring
- PC controlled SA+TG
Parameters
- Display: Resistive touch, 2.8", 320x240 pixels
- Displayed point: max. 290 per scan
- Power supply: 5V USB (0.5 A Max)
- Battery operation: up to 2 hours
Spectrum analyzer Low input mode (MF/HF/VHF)
- Frequency range: 100 kHz ~ 350 MHz
- Max. input level: +10 dBm with 0 dB internal ATT
- Input impedance: 50 Ω (input ATT > 10 dB)
- Compression point: 1 dB at -1 dBm with 0 dB internal ATT
- Phase noise: -90 dB/Hz at 100 kHz offset, and -115 dB/Hz at 1 MHz offset
- Dynamic range: 30 kHz RBW of 70 dB
- Absolute Power lever accuracy: +/-1 dB (after calibration)
- Resolution filters: Manual (3, 10, 30, 100, 300, 600 kHz) or Auto
- Built-in optional 20 dB LNA with Noise Figure of 5 dB
- Screen resolution of 51, 101, 145 or 290
Spectrum analyzer High input mode (UHF)
- Frequency range: 240 to 960 MHz
- Max. input level: +10 dBm with 0 dB internal ATT
- Input impedance: 50 Ω (input ATT > 10 dB)
- Compression point: 1 dB at -6 dBm with 0 dB internal ATT
- Dynamic range: 30 kHz RBW of 50 dB
- Absolute Power lever accuracy: +/-1 dB (after calibration)
- Resolution filters: Manual (3, 10, 30, 100, 300, 600 kHz) or Auto
Signal generator Low output mode
- Sine wave output: 100 kHz to 350 MHz
- Output level: -76 dBm to -6 dBm
- Harmonics: below -40 dB of fundamental
Functionalities: AM, NFM and WFM modulation
Signal generator High output mode
- Square wave output: 240 to 960 MHz
- Output level: -38 dBm to +13 dBm
Functionalities: NFM and WFM modulation
Reference generator spec
- Optional square wave output: -26 dBm @ High output
- Frequency: 1 MHz, 2 MHz, 4 MHz, 10 MHz, 15 MHz or 30 MHz
HW versions and differences
- V0.3.1_E: Added EMC protection diodes
Info & Details
PC control: tinysa.org
Measurement Examples: tinysa.org
Manual: tinysa.org
Included in package
TinySA Spectrum analyzer
2pcs SMA pigtal cable
SMA M-M adapter
Telescopic antenna with SMA (30 cm)
USB-C charging cable
Control pick
Paper box