RX limiter with TX OFF
Simple RF limiter and RX antenna disconnector for your receiver
65.00 € (without tax)
The main purpose of this box is to disconnect the RX antenna from the receiver during transmission using a PTT signal, then the receiver is protected by an RF limiter which limits the maximum signal level and also acts as a common mode filter.
A PTT signal is required to disconnect the RX antenna during transmission. To ensure that you don't lose the PTT signal output from your equipment, this box also has a PTT splitter and a RCA connector with PTT output. The whole PTT logic protects the PTT input - optically isolated - and also allows you to connect other equipment such as a PA etc.. In this way, the box also functions as a protection and separation of the PTT signal from the TRX.
The RF limiter limits the maximum signal level to the RX. This is approximately +13dBm (20mW). The intelligent SuperFuse will protect the RX even if there is a 100W signal at the input of this box and the signal from the antenna is not disconnected by the PTT signal!
Using
- Receiver protection
- Disconnect for RX antenna while TX
- RX RF signal limiter
Main functions
- Broadband: 0.1 MHz to 60 MHz
- Small relay short RF when PTT active
- RF limiter to typ. 13 dBm
- High voltage and current protections
- LED diode for PTT
- PTT IN with optocoupler
- PTT OUT with 0.5 A FET switch
- DC plug included
- 4pcs self adhesive feet pads included
- Aluminium enclosure: W x H x L = 58 x 24 x 50 mm
- ASSEMBLED and TESTED VERSION
Parameters
- Frequency range 0.1 MHz to 60 MHz
- Supply voltage DC 12 V (12 to 14)
- DC current typ. 70 mA
- High RF voltage and current protection (90 V, 100 mA)
- PTT IN current typ. 6 mA
- PTT IN transmitting = connecting to GND
- PTT OUT FET 0.5A DC
- Insertion loss lower than 2 dB
- Isolation (PTT TX) > 80 dB @ MHz
- LED shows PTT active - RED
⚠ NOTE: The PTT circuit only works when DC power supply is applied. PTT OUT does not work without DC power.
Available as
ASSEMBLED with BOX: ready to use
Included in package
Limiter assembled and tested
DC plug - image
4pcs self adhesive feet pads - image
Manual
If you want to know more please check our wiki with RX limiter with TX OFF manual.
Data sheet
- type
- ASSEMBLED
- design
- in enclosure
- usage
- RX
- impedance
- both 50 & 75 Ohm
- front-end protection
- input and output
- frequency range
- 0.1 MHz to 60 MHz
- product dimensions
- 58x50x24 mm - al box
- product weight (brutto)
- 0.14 kg
- package dimensions
- 12x10.5x4.5 cm