PCB for RX Triplexer 2L
This is simply RX triplexer. There are three band pass filters used as splitters or combiners.
14.00 € (without tax)
This PCB is for RX Triplexer 2L. There are three band pass filters used as splitters or combiners. With very lowl oss and very good band pass filtering. You can use it as single band signal combiner or as the multiband antenna splitter.
For example: You can split beverage RX antenna to 160, 80 and 40m outputs for the antenna switches for one RX on each band. Or you can split single band antennas (vertical array, antenna stacks etc) into one output. All bands are filtered by band pas filters. This output you can use for web based SDR or skimmer server for RBN. If you want to split or combine the same bands use 2-WAY SPLITTER.
Using
- One antenna to more single band RX - example
- More antennas to one multiband RX (or more) - example 1, example 2
- Web-based SDR, CW/RTTY/FT skimmer for RBN
Main functions
- Three band pass filters
- Low loss
- More than -35 dB for the neighboring band - More with 3BPF board
- Stackable - more triplexers for more bands
- Protections
- Works as splitter or combiner
- More single band RX from one antenna - example
- More single band antennas to one RX - example 1, example 2
- ONLY PCB
Parameters
- Insertion loss < 1 dB
- Neighboring band filtering: more than 30 dB
- High voltage protection around 65V AC
Available as
KIT: all parts + PCB - KIT VERSION
ASSEMBLED: ready to use - ASSEMBLED VERSION
Manual
If you want to know more please check our wiki with RX Triplexer 2L manual.
example of assembled PCB
160m, rest open
160m, rest with dummy loads
80m, rest open
80m, rest with dummy loads
40m, rest open
40m, rest with dummy loads
Data sheet
- type
- ONLY PCB
- design
- bare pcb
- usage
- RX
- impedance
- both 50 & 75 Ohm
- front-end protection
- input and output
- frequency range
- 160m, 80m and 40m
- PCB dimensions
- 100x100 mm